LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - U250E) >> Shift Lever >> Disassembly

Shift Lever: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY 
    1. Disengage the 4 claws and remove the position indicator housing sub-assembly from the shift lock control unit.
      NOTE: Do not damage the floor shift position indicator housing sub-assembly.
      Fig 1: Identifying Floor Shift Position Indicator Housing Sub-Assembly And Claws
      G06011506Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE SHIFT LOCK RELEASE BUTTON COVER 
    1. Remove the shift lock release button cover from the position indicator housing sub-assembly.
  3. REMOVE POSITION INDICATOR SLIDE COVER 
    1. Remove the position indicator slide cover with the No. 2 position indicator slide cover from the shift lock control unit.
      Fig 2: Identifying Position Indicator Slide Cover
      G06011507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER 
    1. Remove the No. 2 position indicator slide cover from the position indicator slide cover.
      Fig 3: Identifying No 2 Position Indicator Slide Cover
      G06011508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY 
    1. Separate the position indicator light wire socket and connector from the shift lock control unit.
      Fig 4: Identifying Indicator Light Wire Sub-Assembly
      G06011509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, release the stopper.
    3. Using a screwdriver, disengage the locking lug of terminals 7 and 14, and pull the terminals out from the rear of the connector.
  6. REMOVE POSITION INDICATOR LIGHT BULB 
    1. Remove the bulb and cap from the indicator light wire socket.
      Fig 5: Identifying Position Indicator Light Bulb Connector Terminals
      G06011510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE SHIFT LOCK CONTROL ECU SUB-ASSEMBLY 
    1. Separate the connector from the shift lock control ECU sub-assembly.
    2. Disengage the 3 claws and the shift lock control ECU sub-assembly from the shift lock control unit.
      Fig 6: Identifying Shift Lock Control ECU Sub-Assembly And Claws
      G06011511Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002