Park/Neutral Position Switch: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE ENGINE UNDER COVER LH
SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY
1. Remove the nut and disconnect the control cable assembly from the control shaft lever.
2. Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.
  
  Fig 1: Locating Nut And Control Cable Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Disconnect the park/neutral position switch connector.
  
  Fig 2: Locating Park/Neutral Position Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut, washer and control shaft lever.
  
  Fig 3: Locating Nut And Control Shaft Lever With Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, pry up the lock plate.
  
  Fig 4: Prying Up Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the lock nut and the lock plate.
  
  Fig 5: Locating Lock Nut And Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 bolts and pull out the park/neutral position switch.
  
  Fig 6: Locating Bolts And Park/Neutral Position Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002