Oil Pump: Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new oil seal to the oil pump body.
  SST 09350-32014 (09351 -32140)
  
  HINT:
  
  The seal end should be flush with the outer edge of the oil pump.
2. Coat the lip of the oil seal with MP grease.
  
  Fig 1: Installing Oil Seal To Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF, and install it to the oil pump body.
  NOTE:
  - Install the O-ring carefully to avoid twists or pinches.
  - Apply sufficient ATF to the O-ring prior to installation.
  Fig 2: Installing Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side up.
  
  Fig 3: Identifying Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.
  
  Fig 4: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Align the bolt holes in the stator shaft assembly with those in the front oil pump and gear body sub-assembly.
2. Using a "TORX" socket (T30), install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Locating Bolts And Stator Shaft Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 2 new clutch drum oil seal rings with ATF.
2. Install the 2 clutch drum oil seal rings.
  NOTE: Do not expand the ring ends excessively.
  
  Fig 6: Identifying Clutch Drum Oil Seal Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002