DTC P0705 Transmission Range Sensor Circuit Malfunction (PRNDL Input): Description
WARNING: This page is about a different variant/trim than selected.
The park/neutral position switch detects the shift lever position and sends signals to the ECM.
DTC DETECTION CONDITION REFERENCE
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0705 |
- Any 2 or more signals of the following are ON simultaneously (2-trip detection logic)
- P input signal is ON.
- N input signal is ON.
- R input signal is ON.
- D input signal is ON.
- Any 2 or more signals of the following are ON simultaneously (2-trip detection logic)
- NSW input signal is ON.
- R input signal is ON.
- D input signal is ON
- When any of following conditions is met for 2.0 sec. or more in the S position (2-trip detection logic)
- NSW input signal is ON.
- P input signal is ON.
- N input signal is ON.
- R input signal is ON.
- All switches are OFF simultaneously for NSW, P, N, R, D positions (2-trip detection logic).
- NSW input signal is OFF.
- P input signal is OFF.
- N input signal is OFF.
- R input signal is OFF.
- D input signal is OFF
|
- Open or short in park/neutral position switch circuit
- Park/neutral position switch
- ECM
|