LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation / Multi-Info Display >> Navigation Receiver >> Removal

Navigation Receiver: Removal

  1. EJECT MAP DISC 
    1. Turn the ignition switch to ON.
    2. Push the "OPEN" button.
    3. Push the "MAP" button to eject the map disc.
  2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH  (See REMOVAL )
  3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  6. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE NAVIGATION RECEIVER WITH BRACKET 
    1. Remove the 4 bolts.
    2. Disconnect each connector and remove the navigation receiver with bracket.
    Fig 1: Locating Navigation Receiver Bolts
    G06010782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 4 screws and No. 2 radio bracket.
    Fig 2: Locating No. 2 Radio Bracket And Screws
    G06010783Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 4 screws and No. 1 radio bracket.
  11. REMOVE NAVIGATION RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals