Rear No. 2 Suspension Arm: Installation

TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM
1. Install the rear No. 2 suspension arm (inner side) with the bolt, and temporarily tighten the bolt.
  
  Fig 1: Locating Rear No. 2 Suspension Arm (Inner Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Ensure that the paint mark faces to the rear of the vehicle.
2. Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.
  
  Fig 2: Locating Rear No. 2 Suspension Arm (Outer Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE: When temporarily tightening the bolt, keep the nut from rotating.
STABILIZE SUSPENSION (See INSTALLATION )
FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM
1. Fully tighten the bolt.
  Torque: 100 N*m (1,020 kgf*cm, 74 ft.*lbf)
  
  Fig 3: Locating Rear No. 2 Suspension Arm Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt.
  Torque: 100 N*m (1,020 kgf*cm, 74 ft.*lbf)
  
  Fig 4: Tightening Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(See ADJUSTMENT )