Front Suspension Lower No. 1 Arm (2GR-FE): Removal

HINT:

• Use the same procedures for the RH side and the LH side.
• The procedures listed below are for the LH side.

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE 

   HINT:

   Refer to the instructions for installation of the engine assembly (See REMOVAL for 2GR-FE).

2. REMOVE ENGINE MOUNTING INSULATOR 
   1. Remove the 3 nuts and the engine mounting insulator.
      Fig 1: Locating Engine Mounting Insulator

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE FRONT SUSPENSION LOWER NO. 1 ARM 
   1. Remove the 3 bolts and the nut on the front suspension lower No. 1 arm and remove it from the front frame assembly.
      Fig 2: Locating Front Suspension Lower Arm No.1

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the front lower arm bushing stopper.