VANE PUMP (for 2GR-FE): Removal

DRAIN POWER STEERING FLUID
REMOVE FRONT WHEEL RH
REMOVE FRONT FENDER APRON SEAL RH
REMOVE V-BANK COVER SUB-ASSEMBLY
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
DISCONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE
1. Slide the clip and disconnect the No. 1 fluid reservoir to pump hose from the vane pump assembly.
  
  Fig 1: Locating No. 1 Fluid Reservoir To Pump Hose Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT PRESSURE FEED TUBE ASSEMBLY
1. Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.
2. Remove the bolt and separate the pressure feed tube clamp.
3. Remove the gasket from the pressure feed tube assembly.
Fig 2: Disconnecting Pressure Feed Tube Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR
1. Disconnect the power steering fluid pressure switch connector.
  
  Fig 3: Locating Power Steering Fluid Pressure Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VANE PUMP ASSEMBLY
1. Using SST, loosen bolt (A) and remove bolt (B), and then remove the vane pump assembly.
  SST 09249-63010
  
  Fig 4: Removing Vane Pump Assembly Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt from the vane pump assembly.
  
  Fig 5: Identifying Vane Pump Assembly Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002