LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Base, Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Except Hybrid) >> Driver Side Knee Airbag Assembly >> Removal

Driver Side Knee Airbag Assembly: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
  3. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH  (See REMOVAL )
  6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    1. Remove the 4 bolts.
    2. Disconnect the airbag connector.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
      Fig 1: Locating Driver Side Knee Airbag Assembly Bolts
      G04979609Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 2 claws and remove the DLC3 connector.
    4. Disengage the 2 hooks and remove the driver side knee airbag assembly.
    Fig 2: Identifying Driver Side Knee Airbag Assembly Hooks
    G04979610Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals