LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Emission Control System (2AZ-FE) (Except Hybrid) >> Heated Oxygen Sensor >> Installation

Heated Oxygen Sensor: Installation

  1. INSTALL HEATED OXYGEN SENSOR 
    1. Temporarily tighten the heated oxygen sensor.
      NOTE: Do not damage the heated oxygen sensor.
    2. Using SST, fully tighten the heated oxygen sensor.

      SST 09224-00010 

      Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf) 

      Fig 1: Tightening Heated Oxygen Sensor
      G04975143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the heated oxygen sensor connector.
      Fig 2: Identifying Heated Oxygen Sensor Connector
      G04975140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals