Front Brake Pad, Brake Caliper & Brake Rotor: Installation

INSTALL DISC BRAKE CYLINDER ASSEMBLY
1. Install the disc brake cylinder assembly with the 2 bolts.
  Torque: 34 N*m (350 kgf*cm, 25 ft.*lbf)
  
  Fig 1: Installing Disc Brake Cylinder Assembly With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the installation of the anti-squeal springs.
  1. Visually check for any clearance between the brake pad and front disc brake pad support plates as shown in the illustration.
    NOTICE:
    - If the anti-squeal springs are installed correctly, there will be no clearance between the brake pad and the front disc brake pad support plates. If there is a clearance, the anti-squeal springs may not be installed properly.
    - Check all 4 contact surfaces between the brake pad and the front disc brake pad support plates.
  Fig 2: Locating Union Bolt And Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the flexible hose with the union bolt and the new gasket.
NOTE: Install the flexible hose lock securely in the lock hole in the disc brake cylinder.

Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf)
FILL RESERVOIR WITH BRAKE FLUID (See ON-VEHICLE INSPECTION )
BLEED MASTER CYLINDER (See ON-VEHICLE INSPECTION )
BLEED BRAKE LINE (See BLEEDING )
BLEED BRAKE ACTUATOR ASSEMBLY (w/ VSC) (See BLEEDING )
INSPECT BRAKE FLUID LEVEL IN RESERVOIR (See BLEEDING )
INSPECT FOR BRAKE FLUID LEAKAGE
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)