LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior (Except Hybrid) >> Rear Door Black Out Tape >> Removal

Rear Door Black Out Tape: Removal

  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG  (See DISASSEMBLY )
  2. REMOVE DOOR ASSIST GRIP COVER  (See DISASSEMBLY )
  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
  4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP  (See DISASSEMBLY )
  5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY  (See DISASSEMBLY )
  6. REMOVE REAR DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
  7. REMOVE REAR DOOR GLASS RUN  (See DISASSEMBLY )
  8. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY  (See DISASSEMBLY )
  9. REMOVE REAR DOOR QUARTER WINDOW GLASS  (See DISASSEMBLY )
  10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY  (See DISASSEMBLY )
  11. REMOVE REAR DOOR WEATHERSTRIP  (See REMOVAL )
  12. REMOVE REAR DOOR FRAME GARNISH  (See DISASSEMBLY )
  13. REMOVE REAR DOOR OUTSIDE STRIPE 
    1. Using a heat light, heat the rear door outside stripe.

      Heating temperature 

      HEATING TEMPERATURE SPECIFICATIONS

      Item Temperature
      Vehicle Body 40 to 60°C (104 to 140°F)
      NOTE: Do not heat the vehicle body excessively.
    2. Pull back an edge of the rear door outside stripe and pull it parallel to the vehicle body to pull it off.
  14. REMOVE REAR DOOR LOWER OUTSIDE STRIPE 
    1. Using a heat light, heat the rear door tower outside stripe.

      Heating temperature 

      HEATING TEMPERATURE SPECIFICATIONS

      Item Temperature
      Vehicle Body 40 to 60°C (104 to 140°F)
      NOTE: Do not heat the vehicle body excessively.
    2. Pull back an edge of the rear door lower outside stripe and pull it parallel to the vehicle body to pull it off.
scientia non olet · About LEMON Manuals