Inspection Procedure

1. Disconnect the F1 connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   F1-12 (E2) - Body ground	Always	Below 1 Ω
   F1-24 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   F1-13 (IG+) - Body ground	Turn the ignition switch on (IG)	10 to 14 V
   F1-1 (B2) - Body ground	Always	10 to 14 V
   F1-2 (B) - Body ground	Always	10 to 14 V

   Fig 1: Identifying Combination Meter Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE COMBINATION METER ASSEMBLY