LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Avalon XLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Supplemental Restraint System) >> Driver Side Knee Airbag Assembly >> Removal

Driver Side Knee Airbag Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
  3. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH 
  6. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL LH  (See REMOVAL )
  7. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    1. Remove the 4 bolts and the driver side knee airbag assembly.
    2. Disconnect the connector from the driver side knee airbag assembly.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  8. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    Fig 1: Locating Bolts And Driver Side Knee Airbag Assembly
    G05409831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals