Rear Brake Pad, Brake Caliper & Brake Rotor: Removal

HINT:

• Use the same procedure for the LH side and RH side.
• The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL 
2. DRAIN BRAKE FLUID 
   NOTE: If brake fluid leaks onto any painted surface, immediately wash it off.
3. DISCONNECT REAR BRAKE FLEXIBLE HOSE 
   1. Remove the union bolt and the gasket from the rear disc brake cylinder assembly, then disconnect the rear brake flexible hose.
      Fig 1: Locating Rear Brake Flexible Hose

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY 
   1. Hold the 2 rear disc brake cylinder slide pins and remove the 2 bolts and rear disc brake cylinder assembly.