Front Brake Pad, Brake Caliper & Brake Rotor: Installation

INSTALL DISC BRAKE CYLINDER ASSEMBLY
1. Install the disc brake cylinder assembly with the 2 bolts.
  Torque: 34 N*m (350 kgf*cm, 25 ft.*lbf)
  
  NOTE: Be sure that the anti-squeal springs are installed to the front disc brake pads.
  
  Fig 1: Holding Front Disc Brake Cylinder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the flexible hose with the union bolt and a new gasket.
  Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf)
  
  NOTE: Install the front brake flexible hose lock securely in the lock hole in the disc brake cylinder.
  
  Fig 2: Locating Union Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL RESERVOIR WITH BRAKE FLUID (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
INSPECT FOR BRAKE FLUID LEAK
INSPECT BRAKE FLUID LEVEL IN RESERVOIR (See BLEEDING )
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)