Steering Pad: Removal

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION ).

Fig 1: Locating Clearance Between Steering Pad And Steering Wheel

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE NO. 2 STEERING WHEEL COVER LOWER
REMOVE NO. 3 STEERING WHEEL COVER LOWER
REMOVE STEERING PAD ASSEMBLY
1. Straighten the front wheels.
2. Using a T30 "TORX" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
  
  Fig 2: Identifying No. 2 And No. 3 Steering Wheel Cover Lower
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
  NOTE: When removing the steering pad, do not pull the airbag wire harness.
4. Using a screwdriver, disconnect the 2 airbag connectors.
  CAUTION: When handling the airbag connector, do not damage the airbag wire harness.
5. Disconnect the horn connector and remove the steering pad.
  
  Fig 3: Supporting Steering Pad With Hand
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002