Rear Door Lock: Inspection
- INSPECT REAR DOOR LOCK ASSEMBLY LH
- Check the door lock motor operation.
- Apply battery voltage to the door lock connector and check the operation of the door lock.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
OK
MEASUREMENT SPECIFIED CONDITION CHARTMeasurement Condition Specified Condition Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL)Lock Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L)Unlock If the result is not as specified, replace the door lock assembly.
- Check the detection switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Switch Condition Specified Condition 6 (LSSR) - 9 (E) Unlock Below 1 Ω 6 (LSSR) - 9 (E) Lock 10 kΩ or higher If the result is not as specified, replace the door lock assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the door lock motor operation.
- INSPECT REAR DOOR LOCK ASSEMBLY RH
- Check the door lock motor operation.
- Apply battery voltage to the door lock connector and check the operation of the door lock.
OK
MEASUREMENT SPECIFIED CONDITION CHARTMeasurement Condition Specified Condition Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL)Lock Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L)Unlock If the result is not as specified, replace the door lock assembly.
- Check the detection switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Switch Condition Specified Condition 6 (LSSR) - 9 (E) Unlock Below 1 Ω 6 (LSSR) - 9 (E) Lock 10 kΩ or higher If the result is not as specified, replace the door lock assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the door lock motor operation.