Instrument Panel Speaker: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY 
   1. Detach the 8 claws and remove the opening cover.
      Fig 1: Identifying No. 1 Speaker Opening Cover Assembly Claws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY 
   1. Remove the 2 bolts.
   2. Remove the speaker and disconnect the speaker connector.
      NOTE: Do not touch the cone part of the speaker.
4. REMOVE ASSIST GRIP SUB-ASSEMBLY  (See REMOVAL )
5. REMOVE FRONT PILLAR GARNISH LH  (See REMOVAL )
   Fig 2: Locating Front No. 4 Speaker Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 
   1. Detach the 4 claws and remove the speaker panel.
      Fig 3: Identifying No. 1 Instrument Panel Speaker Panel Sub-Assembly Claws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY 
   1. Remove the 2 bolts.
   2. Remove the speaker and disconnect the speaker connector.
      NOTE: Do not touch the cone part of the speaker.
      Fig 4: Locating Front No. 2 Speaker Assembly Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002