Torque Converter Clutch And Drive Plate: Inspection

INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY
1. Inspect the one-way clutch.
  1. Set SST into the inner race of the one-way clutch.
    SST 09350-32014 (09351-32010)
    
    Fig 1: Setting SST Into Inner Race Of One-Way Clutch
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Install SST so that it fits in the notch of the converter hub and outer race of the one-way clutch.
    SST 09350-32014 (09351-32010, 09351-32020)
  3. Stand the torque converter and turn the SST.
    Standard: If the one-way clutch is turned clockwise, it rotates freely, and if turned counterclockwise, it locks.
    
    Fig 2: Turning SST
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Determine the condition of the torque converter clutch assembly.
  1. If the inspection result of the torque converter clutch assembly satisfies the following conditions, replace the torque converter clutch assembly.
    Malfunction item: A metallic sound is emitted from the torque converter clutch assembly during the stall test or when the shift lever is moved to the N position.
    
    The one-way clutch is free or locked in both directions.
    
    The amount of powder in the ATF is greater than the sample shown below (see the sample).
    
    HINT:
    
    The sample shows ATF of approximately 0.25 liters (0.26 US qts, 0.22 Imp. qts) that is taken out from the removed torque converter clutch.
    
    Fig 3: Identifying Minimum Amount Of Powders In ATF
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Exchange ATF in the torque converter clutch.
  1. If the ATF is discolored and/or has a foul odor, completely stir the ATF in the torque converter clutch and drain it.
4. Clean and check the oil cooler and oil pipe line.
  1. If the torque converter clutch is inspected or the ATF is exchanged, clean the oil cooler and oil pipe line.
    HINT:
    - Apply compressed air of 196 kPa (2 kgf/cm² , 28 psi) from the inlet hose.
    - If plenty of fine powders are identified in the ATF, add new ATF using a bucket pump and clean it again.
    Fig 4: Identifying Oil Cooler & Oil Pipe Line
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. If the ATF is cloudy, inspect the oil cooler (radiator).
5. Prevent deformation of the torque converter clutch and damage to the oil pump gear.
  1. When there is any damage on the end of the bolt for the torque converter clutch and on the bottom of the bolt hole, replace the bolt and the torque converter clutch.
  2. All of the bolts must be the same length.
  3. Bolts with washers must be used.
  Fig 5: Identifying Correct & Incorrect Position Of Bolt For Torque Converter Clutch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
1. Set up a dial indicator with a roller instrument and measure the drive plate runout.
  Maximum runout: 0.20 mm (0.0079 in.)
  
  Fig 6: Measuring Drive Plate Runout Using Dial Indicator With Roller Instrument
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check for damage of the ring gear.
  If runout is not as specified or the ring gear is damaged, replace the drive plate.