Rear Axle Hub Bolt: Replacement

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for 2WD) 
   1. Remove the 2 bolts and separate the rear disc brake caliper assembly.
      NOTE: Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
      Fig 1: Identifying Rear Disc Brake Caliper Assembly Bolts (For 2WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for 4WD) 
   1. Remove the 2 bolts and separate the rear disc brake caliper assembly.
      NOTE: Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
      Fig 2: Identifying Rear Disc Brake Caliper Assembly Bolts (For 4WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE REAR DISC  (See DISASSEMBLY )
5. REMOVE REAR AXLE HUB BOLT 
   1. Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown below.
   2. Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

      SST 09628-10011 

      Fig 3: Identifying Nuts & Washers With Rear Axle Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL REAR AXLE HUB BOLT 
   1. Install a washer and nut to a new rear axle hub bolt as shown below.
   2. Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
   Fig 4: Identifying Rear Axle Hub Bolt
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. INSTALL REAR DISC  (See REASSEMBLY )
8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for 2WD) 
   1. Install the rear disc brake caliper assembly with the 2 bolts.

      Torque: 78 N*m (795 kgf*cm, 57 ft.*lbf) 

      Fig 5: Identifying Rear Disc Brake Caliper Assembly Bolts (For 2WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for 4WD) 
   1. Install the rear disc brake caliper assembly with the 2 bolts.

      Torque: 78 N*m (795 kgf*cm, 57 ft*lbf) 

      Fig 6: Identifying Rear Disc Brake Caliper Assembly Bolts (For 4WD)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. INSTALL REAR WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)