FRONT SEAT ASSEMBLY (for Manual Seat): Disassembly
- REMOVE VERTICAL SEAT ADJUSTER KNOB
- Using a screwdriver wrapped with protective tape, remove the snap ring as shown below.NOTE: Be careful not to lose snap ring.
- Remove the vertical seat adjuster knob.
- Using a screwdriver wrapped with protective tape, remove the snap ring as shown below.
- REMOVE RECLINING ADJUSTER RELEASE HANDLE
- Using a screwdriver wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.
- REMOVE VERTICAL ADJUSTER COVER
- Using a screwdriver wrapped with protective tape, disengage the 2 claws and remove the vertical adjuster cover.
- REMOVE VERTICAL ADJUSTING HANDLE
- Remove the 2 screws and the vertical adjusting handle.
- REMOVE FRONT SEAT CUSHION SHIELD
- Disengage the hooks.
- Remove the 3 screws.
- Disengage the claw.
- Disengage the 2 guides and remove the front seat cushion shield.
- REMOVE FRONT SEAT INNER BELT ASSEMBLY (See REMOVAL )
- REMOVE FRONT SEAT CUSHION INNER SHIELD
- Remove the screw.
- Disengage the claw.
- Separate the guide and remove the front seat cushion inner shield as shown below.
- REMOVE FRONT SEAT CUSHION COVER WITH PAD
- Disengage the clamp.
- for Front Passenger Side:
- w/ Seat Heater System:
Disconnect the seat heater connector.
- w/ Seat Heater System:
- Using a clip remover, remove the 2 clips.
- Disengage the hooks and remove the front seat cushion cover with pad as shown below.
- REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
- Remove the 6 hog rings.
- Remove the 11 hog rings and the separate type front seat cushion cover.
- REMOVE FRONT SEATBACK COVER WITH PAD
- Remove the 3 hog rings.
- Remove the 5 hog rings.
- Disengage the 2 hooks.
- Turn back the separate type front seatback cover to remove the nut, and separate the bracket of the separate type front seatback cover.
- Disengage the 4 claws and remove the 2 front seat headrest supports.
- Remove the separate type front seatback cover with pad from the front seat frame assembly with adjuster.
- REMOVE SEPARATE TYPE FRONT SEATBACK COVER
- Remove the 7 hog rings and the separate type front seatback cover.
- REMOVE ACTIVE HEADREST UPPER UNIT
- Remove the nut and disconnect the cable from the active headrest upper unit as shown below.
- Remove the 4 nuts and the active headrest upper unit.
- REMOVE ACTIVE HEADREST LOWER UNIT
- Remove the 4 nuts and the active headrest lower unit.
- REMOVE RECLINING ADJUSTER INSIDE COVER LH
- Remove the screw.
- Disengage the clamp.
- Disengage the guide and remove the reclining adjuster inside cover LH.
- REMOVE RECLINING ADJUSTER INSIDE COVER LH
- Remove the screw.
- Disengage the claw and remove the reclining adjuster inside cover LH.
- REMOVE RECLINING ADJUSTER INSIDE COVER RH
- Remove the screw.
- Disengage the guide and remove the reclining adjuster inside cover RH.
- REMOVE RECLINING ADJUSTER INSIDE COVER RH
- Remove the screw.
- Disengage the claw and remove the reclining adjuster inside cover RH.
- REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
- Remove the screw.
- Disengage the claw and remove the front seat lower cushion shield LH as shown below.
- REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
- Remove the screw.
- Disengage the claw and the guide, and remove the front seat lower cushion shield RH as shown below.
- REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY (for Front Passenger Side)
- w/ Seat Heater System:
Disengage the 2 clamps and remove the seat heater control sub-assembly.
- w/ Seat Heater System:
- REMOVE SEAT POSITION SENSOR (See REMOVAL )
- REMOVE OCCUPANT CLASSIFICATION ECU (for Front Passenger Side) (See REMOVAL )
- REMOVE FRONT SEAT WIRE RH (for Front Passenger Side)
- Disengage the each clamps and remove the front seat wire RH.