Front Bumper: Removal

REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE RADIATOR GRILLE (See REMOVAL )
REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)
1. Put protective tape around the front bumper assembly.
  HINT:
  
  Use the same procedure for the RH side and LH side.
  
  Fig 1: Identifying Protective Tape Around Front Bumper Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the screw.
  HINT:
  
  Use the same procedure for the RH side and LH side.
  
  Fig 2: Identifying Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
  HINT:
  
  Use the same procedure for the RH side and LH side.
4. Remove the 7 screws and clip.
  
  Fig 3: Identifying Screws & Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Disengage the 4 claws and disconnect the front bumper assembly.
  HINT:
  
  Use the same procedure for the RH side and LH side.
6. Remove the front bumper assembly.
  
  Fig 4: Identifying Front Bumper Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)
1. Put protective tape around the front bumper assembly.
  HINT:
  
  Use the same procedure for the RH side and LH side.
  
  Fig 5: Identifying Protective Tape Around Front Bumper Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the screw.
  HINT:
  
  Use the same procedure for the RH side and LH side.
  
  Fig 6: Identifying Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
  HINT:
  
  Use the same procedure for the RH side and LH side.
4. Remove the 7 screws and clip.
  
  Fig 7: Identifying Screws & Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Disengage the 4 claws and disconnect the front bumper assembly.
  HINT:
  
  Use the same procedure for the RH side and LH side.
  
  Fig 8: Identifying Front Bumper Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Disconnect each fog light connector, and then remove the front bumper assembly.