LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Power Back Door Opener/Closer Switch >> Inspection

Power Back Door Opener/Closer Switch: Inspection

  1. INSPECT POWER BACK DOOR OPENER/CLOSER SWITCH 
    1. Measure the resistance of the switch.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Switch Condition Specified Condition
      4-1 Pushed (ON) Below 1 Ω
      4-1 Free (OFF) 10 kΩ or higher

      If the result is not as specified, replace the switch.

    2. Check that the switch illuminates.

      Standard resistance 

      MEASUREMENT SPECIFIED CONDITION

      Measurement Condition Specified Condition
      Battery positive (+) → 3 (ILL+)
      Battery negative (-) → 2 (ILL-)      		 Illuminates
      Fig 1: Identifying Power Back Door Opener/Closer Switch
      G05422038Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the switch.

scientia non olet · About LEMON Manuals