LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Power Back Door Main Switch >> Inspection

Power Back Door Main Switch: Inspection

  1. INSPECT POWER BACK DOOR MAIN SWITCH 
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION TABLE

      Tester Connection Switch Condition Specified Condition
      1 - 2 Free (OFF) 10 kΩ or higher
      1 - 2 Pushed (ON) Below 1 Ω
      Fig 1: Identifying Power Back Door Main Switch
      G05422035Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the switch.

scientia non olet · About LEMON Manuals