Steering Pad Switch: Installation

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 pins and install the steering pad switch.
  
  Fig 1: Identifying Steering Pad Switch Pins
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the screw.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
3. Engage the 2 pins and install the steering pad switch assembly.
4. Install the screw.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  
  Fig 2: Identifying Steering Pad Switch Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the pad switch connector to the spiral cable.
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT STEERING PAD (See ON-VEHICLE INSPECTION )
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).