LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Horns >> Horn (Except Hybrid) >> Spiral Cable >> Removal

Spiral Cable: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION ).
  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  6. REMOVE STEERING PAD  (See REMOVAL )
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  8. REMOVE STEERING COLUMN COVER  (See REMOVAL )
  9. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR  (See REMOVAL )
  10. REMOVE SPIRAL CABLE 
    1. Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.
      Fig 1: Identifying Spiral Cable Claws & Pins
      G05419253Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals