LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - U151F (Except Hybrid) >> Speed Sensor >> Removal

Speed Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE BATTERY  (See REMOVAL )
  3. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  4. REMOVE NO. 2 AIR CLEANER INLET  (See REMOVAL )
  5. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE AIR CLEANER BRACKET  (See REMOVAL )
  10. REMOVE SPEED SENSOR (NT SENSOR) 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and speed sensor.
      3. Fig 1: Identifying Bolt & Speed Sensor Connector (NT Sensor)
      G05001115Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE SPEED SENSOR (NC SENSOR) 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and speed sensor.
      3. Fig 2: Identifying Bolt & Speed Sensor Connector (NC Sensor)
      G05001116Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals