Front Seat Outer Belt Assembly With PRETENSIONER: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See PRECAUTION ).

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE FRONT DOOR SCUFF PLATE (See REMOVAL )
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
REMOVE REAR DOOR SCUFF PLATE (See REMOVAL )
DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
REMOVE LOWER CENTER PILLAR GARNISH (See REMOVAL )
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
1. Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
REMOVE CENTER PILLAR GARNISH (See REMOVAL )

Fig 1: Identifying Front Seat Outer Belt Assembly & Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SEAT OUTER BELT ASSEMBLY
1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
  
  Fig 2: Identifying Front Seat Outer Belt Assembly & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown below.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 3: Pulling Locking Button
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 2 bolts and front seat outer belt assembly.
  
  Fig 4: Identifying Front Seat Outer Belt Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
1. Remove the 2 bolts and front shoulder belt anchor adjuster assembly.
  
  Fig 5: Identifying Front Shoulder Belt Anchor Adjuster Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002