Front Seat Outer Belt Assembly With PRETENSIONER: Installation

INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
1. Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 1: Identifying Front Shoulder Belt Anchor Adjuster Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT SEAT OUTER BELT ASSEMBLY
1. Temporarily install the front seat outer belt assembly with the 2 bolts.
  
  Fig 2: Identifying Front Seat Outer Belt Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt < A > first, then the bolt < B > to install the front seat outer belt assembly.
  Torque: Bolt < A >
  
  7.5 N*m (77 kgf*cm, 66 in.*lbf)
  
  Bolt < B >
  
  42 N*m (428 kgf*cm, 31 ft.*lbf)
3. Connect the connector and lock the locking button as shown below.
  NOTE: Securely lock the locking button.
  
  Fig 3: Identifying Connector & Locking Button
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the shoulder anchor of the front seat outer belt assembly with the nut.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 4: Identifying Front Seat Outer Belt Assembly & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CENTER PILLAR GARNISH (See INSTALLATION )
CONNECT FRONT SEAT OUTER BELT ASSEMBLY
1. Install the floor end of the front seat outer belt assembly with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 5: Identifying Front Seat Outer Belt Assembly Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check if the ELR locks.
  NOTE: The check should be performed with the outer belt assembly installed.
  1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
INSTALL LOWER CENTER PILLAR GARNISH (See INSTALLATION )
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )