LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System (2GR-FE) (Except Hybrid) >> Fuel Sender Gauge Assembly >> Inspection

Fuel Sender Gauge Assembly: Inspection

  1. INSPECT FUEL SENDER GAUGE ASSEMBLY 
    1. Remove the fuel sender gauge assembly.
    2. Check the operation of the float moving smoothly between F and E.
    3. Measure the resistance between terminals 2 (FE) and 3 (FS). of the connector according to the value(s) in the table below.

      OK 

      RESISTANCE SPECIFICATION TABLE

      Float Level Resistance (Ω)
      F 3.0 to 5.0
      E 109.0 to 111.0

      HINT:

      If the value is not as specified, replace the fuel sender gauge assembly.

    Fig 1: Identifying Fuel Sender Gauge Assembly Connector Terminals
    G05414912Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals