Front Brake Pad, Brake Caliper & Brake Rotor: Installation

INSTALL DISC BRAKE CYLINDER ASSEMBLY
1. Hold the front disc brake cylinder slide pins and install the disc brake cylinder assembly with the 2 bolts.
  Torque: 34 N*m (347 kgf*cm, 25 ft.*lbf)
  
  NOTE: Be sure that the anti-squeal springs are installed to the front disc brake pads.
  
  Fig 1: Identifying Disc Brake Cylinder Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FRONT FLEXIBLE HOSE
1. Connect the front flexible hose with the union bolt and a new gasket to the disc brake cylinder assembly.
  Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
  
  NOTE: Install the front flexible hose lock securely in the lock hole in the disc brake cylinder assembly.
  
  Fig 2: Identifying Front Flexible Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL BRAKE FLUID RESERVOIR (See ON-VEHICLE INSPECTION )
BLEED BRAKE LINE (See ON-VEHICLE INSPECTION )
BLEED BRAKE ACTUATOR (See ON-VEHICLE INSPECTION )
INSPECT FLUID LEVEL (See ON-VEHICLE INSPECTION )
INSPECT FOR BRAKE FLUID LEAK
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)