Front Brake Flexible Hose: Removal

NOTE: If both the RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

DRAIN BRAKE FLUID
REMOVE FRONT WHEEL
REMOVE FRONT FLEXIBLE HOSE
1. Remove the union bolt and gasket, and separate the front flexible hose.
  
  Fig 1: Identifying Front Flexible Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a union nut wrench (10 mm), disconnect the brake line from the front flexible hose while holding the front flexible hose with a wrench.
  NOTE:
  - Do not bend or damage the brake line.
  - Do not allow any foreign matter such as dirt and dust to enter the brake lines.
  Fig 2: Disconnecting Brake Line From Front Flexible Hose Using Union Nut Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the clip.
  
  Fig 3: Identifying Front Flexible Hose Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the bolt and front flexible hose from the absorber bracket.
  
  Fig 4: Identifying Front Flexible Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002