LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical (Except Hybrid) >> Brake Pedal >> Reassembly

Brake Pedal: Reassembly

  1. INSTALL BRAKE PEDAL PAD 
    1. Install the brake pedal pad.
  2. INSTALL BRAKE PEDAL BUSHING 
    1. Apply lithium soap base glycol grease to 2 new brake pedal bushings.
    2. Install the 2 brake pedal bushings to the brake pedal sub-assembly.
  3. INSTALL BRAKE PEDAL SHAFT COLLAR 
    1. Install the brake pedal shaft collar to the brake pedal sub-assembly.
  4. INSTALL BRAKE PEDAL SUB-ASSEMBLY 
    1. Install the brake pedal sub-assembly to the brake pedal support sub-assembly with the bolt and nut as shown below.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      Fig 1: Identifying Brake Pedal Sub-Assembly To Brake Pedal Support Sub-Assembly With Bolt & Nut
      G05417903Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 2 clamps.
      Fig 2: Identifying Brake Pedal Clamps
      G05417902Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals