LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation (Except Hybrid) >> Navigation Antenna >> Installation

Navigation Antenna: Installation

  1. INSTALL NAVIGATION ANTENNA ASSEMBLY 
    1. Install the navigation antenna with the 2 screws.
      Fig 1: Identifying Navigation Antenna Assembly Screws
      G05420945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 3 clamps and install the navigation antenna assembly.
      Fig 2: Identifying Navigation Antenna Assembly Clamps
      G05420946Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CENTER HEATER TO REGISTER SUB DUCT  (See REASSEMBLY )
  3. INSTALL DEFROSTER NOZZLE ASSEMBLY  (See REASSEMBLY )
  4. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT  (See REASSEMBLY )
  5. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT  (See REASSEMBLY )
  6. INSTALL NO. 4 HEATER TO REGISTER DUCT  (See REASSEMBLY )
  7. INSTALL NO. 1 HEATER TO REGISTER DUCT  (See REASSEMBLY )
  8. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY  (See INSTALLATION )
  9. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY  (See INSTALLATION )
  10. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)  (See INSTALLATION )
  11. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See INSTALLATION )
  12. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side) 

    HINT:

    Use the same procedure for the RH side and the LH side.

  13. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See INSTALLATION )
  14. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  15. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
  16. INSTALL FRONT PILLAR GARNISH RH  (See INSTALLATION )
  17. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  18. INSTALL ENGINE SWITCH (w/ Smart Key System)  (See INSTALLATION )
  19. INSTALL FRONT NO. 2 CONSOLE BOX INSERT  (See INSTALLATION )
  20. INSTALL FRONT NO. 1 CONSOLE BOX INSERT  (See INSTALLATION )
  21. INSTALL CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System)  (See INSTALLATION )
  22. INSTALL CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System)  (See INSTALLATION )
  23. INSTALL LOWER REAR CONSOLE BOX  (See INSTALLATION )
  24. INSTALL NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System)  (See INSTALLATION )
  25. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  26. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY  (See INSTALLATION )
  27. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  28. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)  (See INSTALLATION )
  29. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)  (See INSTALLATION )
  30. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH  (See INSTALLATION )
  31. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  32. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT:

    Use the same procedure for the RH side and the LH side.

  33. INSTALL FRONT DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedure for the RH side and the LH side.

  34. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET  (See INSTALLATION  )
  35. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)  (See INSTALLATION )
  36. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)  (See INSTALLATION )
  37. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System)  (See INSTALLATION )
  38. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)  (See INSTALLATION )
  39. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  (See INSTALLATION )
  40. INSTALL COMBINATION METER ASSEMBLY  (See REASSEMBLY )
  41. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY  (See REASSEMBLY )
  42. POSITION FRONT WHEELS STRAIGHT AHEAD 
  43. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  44. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  45. ADJUST SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  46. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  47. INSPECT STEERING WHEEL CENTER POINT 
  48. INSTALL STEERING PAD  (See INSTALLATION )
  49. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  50. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  51. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  52. INSPECT STEERING PAD  (See INSTALLATION )
  53. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals