LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Except Hybrid) >> Meter/Gauge System >> Initialization

Meter/Gauge System: Initialization

  1. OIL REPLACEMENT INFORMATION MODE RESET OPERATION 

    HINT:

    • The TRIP meter reset knob is located below the speedometer.
    • This reset operation is required only for U.S.A..
    1. Turn the ignition switch on (IG).
    2. Press the ODO/TRIP switch until the ODO meter appears.
    3. Turn the ignition switch off.
    4. Turn the ignition switch on (IG) while pressing and holding the TRIP meter reset knob. Hold the TRIP meter reset knob until the following conditions are met and 5 seconds have passed.
      Fig 1: Identifying Multi-Information Display Table
      G05420375Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • The multi-information display shows "Resetting Oil Maintenance Data".
      • When oil replacement reminder light turns off, the reset is complete.
scientia non olet · About LEMON Manuals