LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Except Hybrid) >> Meter/Gauge System >> Data List/Active Test

Data List/Active Test

  1. Data List 

    Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Warm up the engine.
    2. Ignition switch off.
    3. Connect Techstream to the DLC3.
    4. Ignition switch on (IG).
    5. Turn the tester on.
    6. Enter the following menus:
      1. for Combination Meter: Body Electrical / Combination Meter / Data List.
      2. for ABS / TRAC / VSC: Chassis / ABS / VSC / TRAC / Data List.
      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.
      4. for Main Body: Body Electrical / Main Body / Data List.
    7. Check values by referring to the table below.

      Combination Meter: 

      FAIL-SAFE TABLE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Cancel SW Tail cancel switch is OFF/ON OFF: Turn the light control rheostat knob is not fully downwards -
      ON: Turn the light control rheostat knob fully upwards -
      ODO/TRIP Change SW ODO/TRIP switch is OFF/ON OFF Switch is released -
      ON: Switch is pushed -
      Vehicle Speed Meter Vehicle speed/Min. 0 km/h (0 mph), Max. 255 km/h (158 mph) Almost same as actual vehicle speed (When driving) -
      Engine Rpm Engine speed/Min. 0 rpm, Max. 12750 rpm Almost same at the meter rpm (When engine is running) -
      Coolant Temperature Engine coolant temperature 0°C (32°F) to 127.5°C (261.5°F) After warming up 80 to 95°C (176 to 203°F) -
      Washer Switch Washer level switch is OFF/ON OFF Washer level is not low -
      ON Washer level is low -
      Multi Display Select Switch MODE switch in the steering pad is OFF/ON OFF Mode switch is OFF -
      ON Mode switch is ON -
      +B Voltage Value Battery voltage/Min. 0 V, Max. 25.5 V 10 to 14 V -
      Integrated value for Oil Maintenance ((1)) Oil maintenance warning value Min. 0, Max. 25500 (mile) The running distance after performing oil maintenance resetting procedure is displayed If the value is 5000 (mile) or more, perform oil maintenance resetting procedure after changing the oil
      Fuel Input Fuel input signal Min. 0, Max. 127.5 Fuel gauge indicates (E) 75 (L) -
      Fuel gauge indicates (1/2) 35.0 (L) -
      Fuel gauge indicates (F) 62.9 (L) -
      Ambient Temperature Outside temperature Min. -40°C (-40°F) to 50°C (122°F) Almost same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
      Rheostat value Light Control Rheostat/Min. 0%, Max 100% Light control rheostat switch is Dark (0%) → Bright (100%) -
      Quantity of Outside Light Quantity of outside light/Min. 0%, Max. 100% Outside light is Dark (0%) → Bright (100%) -
      Key Remind Sound The cycle of the key reminder warning buzzer is displayed The cycle of the key reminder warning buzzer is Large, Medium, Small -
      Key Remind Volume The volume of the key reminder warning buzzer is displayed The volume of the key reminder warning buzzer is Fast, Normal, Slow -
      D-Seatbelt Warning Buzzer The condition of the driver side seat belt warning buzzer ON The driver side seat belt warning buzzer sounds at the vehicle speed is 20 km/h (12 mph) or more when the driver side seat belt is unfastened -
      OFF- The driver side seat belt warning buzzer does not sound at the vehicle speed is 20 km/h (12 mph) or more when the driver side seat belt is unfastened -
      P-Seatbelt Warning Buzzer The condition of the front passenger side seat belt warning buzzer ON The front passenger side seat belt warning buzzer sounds at the vehicle speed is 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened -
      OFF The front passenger side seat belt warning buzzer does not sound at the vehicle speed is 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened -
      Units By Region The type of the unit in the multi-information display The customized setting of the multi-information display unit is displayed -
      Number of Trouble Code The number of the DTC which is currently output 0 -
      (1) for U.S.A.

      ABS/VSC/TRAC: 

      FAIL-SAFE TABLE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      FR/FL/RR/RL Wheel Speed Vehicle speed/Min. 0 km/h (0 mph), Max. 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -
      Vehicle Speed Vehicle speed/Min. 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed (When driving) -

      Engine and ECT: 

      FAIL-SAFE TABLE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Engine Speed Vehicle speed/Min. 0 rpm, Max.: 16383.75 rpm Almost same as actual engine speed (When engine running) -
      Coolant Temp Engine coolant temperature Min. -40°C (-40°F), Max. -140°C (284°F) 80 to 100°C (176 to 212°F) After warming up
      • If -40°C (-40°F): sensor circuit open
      • If 140°C (284°F) or more: sensor circuit shorted

      Main Body: 

      FAIL-SAFE TABLE

      Tester Display Test Part Control Range Diagnostic Note
      Illumination Rate Info Illumination rate information / 0 ms. to 99.99 ms 0.8 to 22.0 ms. (Value is output according to outside illuminance) -
  2. Active Test 

    Using Techstream to perform Active Tests allows the relay, actuator, and other items to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Test.

    1. Connect Techstream to the DLC3.
    2. Ignition switch on (IG).
    3. Turn the tester on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. Check the operation by referring to the table below.

      Combination Meter: 

      FAIL-SAFE TABLE

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120 mph ((1)) -
      0, 40, 80, 120, 160, 200, 240 km/h ((2))) -
      Tacho Meter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) -
      Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL Confirm that the vehicle is stopped, engine idling
      A/T Indicator Operation 1 A/T shift indicator light A/T shift indicator light D, N, R, P is OFF/ON Confirm that the vehicle is stopped, engine idling
      A/T Indicator Operation 2 A/T gear range indicator light A/T gear range indicator light S is OFF/ON Confirm that the vehicle is stopped, engine idling
      Meter Display 1 ((3)) Multi-information display All the dots in the multi-information display OFF/ON Confirm that the vehicle is stopped, engine idling
      Meter Display 2 A/T shift indicator display The segments in the A/T shift indicator display OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Airbag Airbag warning light SRS warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Doors All Open Open door warning light Open door warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      P-seat Belt Front passenger side seat belt warning light Front passenger side seat belt warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      D-seat Belt Driver side seat belt warning light Driver side seat belt warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp ABS ABS warning light ABS warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Slip Slip indicator light Slip indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Charge Charge warning light Charge warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Beam Hi-beam indicator light Hi-beam indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Head ((2)) Head indicator light Head indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Tail ((3)) Tail indicator light Tail indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Fr FOG Front fog indicator light Front fog indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Washer Washer indicator light Washer level warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp Fuel Low fuel warning light Fuel level warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Tire Pressure Warning System ((4)) Tire pressure warning light Tire pressure warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Oil Pressure Oil pressure warning light Oil pressure warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Lamp ECT SNOW ECT SNOW indicator light ECT SNOW indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      A/T Oil Temperature Operation A/T fluid temperature indicator light A/T fluid temperature warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Cruise Cruise indicator light Cruise indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Lamp Brake Brake warning light Brake warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. EPS EPS warning light EPS warning light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat Oil Maintenance Oil replacement reminder light Oil replacement reminder light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Master Warning Master caution indicator light Master caution indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. Downhill Assist Control Downhill assist control indicator light Downhill assist control indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Indicat. VSC OFF VSC off indicator light VSC off indicator light is OFF/ON Confirm that the vehicle is stopped, engine idling
      Water Temperature Meter Operation Engine coolant temperature receiver gauge Low, Normal, High Confirm that the vehicle is stopped, engine idling
      (1) for U.S.A.
      (2) except for U.S.A.
      (3) w/ Multi-information Display
      (4) w/ Tire Pressure Warning System
scientia non olet · About LEMON Manuals