Inspection Procedure

1. Connect Techstream to the DLC3.
2. Ignition switch on (IG).
3. Turn the tester on.
4. Clear the stored DTCs by selecting the following menu items on the tester: Body Electrical / Trouble Codes.
5. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.
6. Stop the vehicle.
7. Check for DTCs (See DIAGNOSIS SYSTEM ).

   Result 

   RESULT TABLE
   
   

   Result	Proceed to
   DTC is output.	A
   DTC is not output.	B

   HINT:

   If the CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0129 first.

B: USE SIMULATION METHOD TO CHECK  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: GO TO CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )