LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine Mechanical (2AZ-FE)) >> Cylinder Head >> Repair

Cylinder Head: Repair

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. REPAIR VALVE SEATS 
    1. If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.
    2. If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.

      Standard width 

      STANDARD WIDTH

      Item Standard Condition
      Intake 1.0 to 1.4 mm (0.0394 to 0.0551 in.)
      Exhaust 1.2 to 1.6 mm (0.0427 to 0.0630 in.)
      Fig 1: Identifying Valves Seats Angle
      G04484820Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Lap the valve and valve seat by hand with an abrasive compound.
    4. Recheck the valve seating position.
scientia non olet · About LEMON Manuals