Data List / Active Test
WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Select the following menu items: DIAGNOSIS / OBD / MOBD / METER / DATA LIST.
- Check the results by referring to the table below.
Combination meter
COMBINATION METER REFERENCEItem Measurement Item / Display (Range) Normal Condition Diagnostic Note +B VOLTAGE VAL Vehicle battery voltage / Min.: 0 V, Max.: 25.5 V 11 to 14 V - SPEED METER Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed (When driving) - TACHO METER Engine speed / Min.: 0 RPM, Max.: 12,750 RPM Almost same as actual engine speed (When engine is running) - FUEL GAUGE (A/D) Fuel input signal / Min.: 0, Max.: 255 Fuel gauge indicates (F): 33
Fuel gauge indicates (3/4): 98
Fuel gauge indicates (1/2): 144
Fuel gauge indicates (1/4): 179
Fuel gauge indicates (E): 206- COOLANT TEMP Coolant temperature / Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) After warning up: 80 to 95°C (176 to 203°F) If the value is "0°C (32°F)" or "127.5°C (261.5°F)", sensor circuits are open or shorted. OIL MAINTENANCE Oil maintenance warning integration value / Min.: 0, Max.: 255 (100 mile) Current vehicle condition is displayed If the value is 50 (5,000 miles) or more, perform the reset operation after changing the oil ODO / TRIP SW ODO / TRIP switch / ON or OFF ON: Switch is pushed
OFF: Switch is released- TAIL CANCEL SW TAIL CANCEL switch / ON or OFF ON: Tail cancel available
OFF: Tail cancel unavailable- RHEOSTAT (A/D) Light control rheostat volume/Min.: 0, Max.: 255 Light control rheostat Min. position: 0
Light control rheostat Max. position: 255- OUTSIDE LIGHT Outside light control output / Min.: 0%, Max.: 100% Current vehicle condition is displayed - AMBI TEMP (A/D) Outside temperature input / Min.: 0, Max.: 255 Current outside temperature conditions
40°C (104°F): 78
25°C (77°F): 98
0°C (32°F): 135- SEAT-BELT WARN Seat belt warning buzzer / D/P ON, D ON, P ON or D/P OFF D/P ON: Driver and passenger buzzer ON
D ON: Driver buzzer ON
P ON: Passenger buzzer ON
D/P OFF: Driver and passenger buzzer OFFCurrent vehicle condition is displayed #CODE Number of diagnosis codes /
Min.: 0, Max.: 255- - ECM/MTR COM DTC DTC is displayed - - ODO (HISTORY 1) Value when DTC is output / Min.: 0 km, Max.: 999999 km - - ODO (HISTORY 2) Value when DTC is output / Min.: 0 km, Max.: 999999 km - - ODO (HISTORY 3) Value when DTC is output / Min.: 0 km, Max.: 999999 km - - ABS/MTR COM DTC DTC is displayed - - ODO (HISTORY 1) Value when DTC is output / Min.: 0 km, Max.: 999999 km - - ODO (HISTORY 2) Value when DTC is output / Min.: 0 km, Max.: 999999 km - - ODO (HISTORY 3) Value when DTC is output / Min.: 0 km, Max.: 999999 km - - - PERFORM ACTIVE TEST
HINT:
Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts.
Performing the ACTIVE TEST early in troubleshooting is one way to save time.
The DATA LIST can be displayed during the ACTIVE TEST.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Select the following menu items: DIAGNOSIS / OBD / MOBD / METER / ACTIVE TEST.
- Perform the ACTIVE TEST by referring to the table below.
Combination meter
COMBINATION METER REFERENCEItem Test Details Diagnostic Note SPEED METER 0 / 40 / 80 / 120 / 160 / 200 / 240 km/h Value selected during ACTIVE TEST is displayed TACHOMETER 0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 RPM Value selected during ACTIVE TEST is displayed FUEL GAUGE EMPTY / 1/2 / FULL Value selected during ACTIVE TEST is displayed COOLANT TEMP LOW / NORMAL / HIGH Value selected during ACTIVE TEST is displayed A/T INDEC (1) P / R / N / D / 4 / 3 / 2 / L Position selected during ACTIVE TEST illuminates LOW / NORMAL / HIGH BEAM indicator light
ON / OFF- HEADLIGHT INDIC*1 HEAD indicator light
ON / OFF- TAILLIGHT INDIC*2 TAIL indicator light
ON / OFF- Fr FOG INDIC Fr FOG indicator light
ON / OFF- Rr FOG INDIC Rr FOG indicator light
ON / OFF- SRS WARN AIRBAG warning light
ON / OFF- D-BELT REMIND D-SEAT BELT indicator light
ON / OFF- P-BELT REMIND P-SEAT BELT indicator light
ON / OFF- DOORS ALL OPEN DOOR warning light
ON / OFF- LOW FUEL WARN FUEL warning light
ON / OFF- DISCHARGE WARN CHARGE warning light
ON / OFF- ABS WARN ABS warning light
ON / OFF- SLIP INDIC SLIP indicator light
ON / OFF- VSC WARN VSC warning light
ON / OFF- 4WD INDIC 4WD indicator light
ON / OFF- BRAKE WARN BRAKE warning light
ON / OFF- A/T OIL TEMP A/T OIL indicator light
ON / OFF- EPS INDIC P/S indicator light
ON / OFF- CRUISE INDIC CRUISE indicator light
ON / OFF- OIL MAINTENANCE*1 MAINT REQD indicator light
ON / OFF- 4WD LOCK INDIC DIF. LOCK indicator light
ON / OFF- AUTO LSD INDIC AUTO LSD indicator light
ON / OFF- DAC INDIC Downhill assist control indicator light
ON / OFF- HINT:
*1: U.S.A.
*2: Except U.S.A.