Typical Enabling Conditions
WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
All
TYPICAL ENABLING CONDITIONS TABLE - ALL
| Monitor will run whenever these DTCs are not present | P0100 - P0103 (MAF sensor) P0110 - P0113 (IAT sensor) P0115 - P0118 (ECT sensor) |
Case 1
TYPICAL ENABLING CONDITIONS TABLE - CASE 1
| Engine coolant or intake air temperature at engine start | "Closed-loop enable temperature -8.34°C (17°F)" or more |
| Engine | Running |
| Fuel cut | OFF |
Case 2
TYPICAL ENABLING CONDITIONS TABLE - CASE 2
| Engine coolant or intake air temperature at engine start | Between "Closed-loop enable temperature -19.45°C (-3°F)" and "Closed-loop enable temperature -8.34°C (17°F)" |
| Engine | Running |
| Fuel cut | OFF |
Case 3
TYPICAL ENABLING CONDITIONS TABLE - CASE 3
| Engine coolant or intake air temperature at engine start | Lower than "Closed-loop enable temperature -19.45°C (-3°F)" or more |
| Engine | Running |
| Fuel cut | OFF |
| Idle | OFF |