LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 933 (Engine Control System - Diagnostic Codes (2 Of 3)) >> DTC P043E, P043F, P2401, P2402, P2419: Evaporative Emission System Reference Orifice Clog Up; Evaporative Emission System Reference Orifice High Flow; Evaporative Emission Leak Detection Pump Stuck OFF; Evaporative Emission Leak Detection Pump Stuck ON; Evaporative Emission System Switching Valve Control Circuit Low >> DTC Summary

DTC Summary

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
EVAPORATIVE EMISSIN SYSTEM

DTC Monitoring Item Malfunction Detection Condition Trouble Area Detection Timing Detection Logic
P043E Reference orifice clogged P043E, P043F, P2401, P2402 and P2419 present when one of following conditions met during key-off EVAP monitor:
  • Reference orifice clogged
  • Reference orifice high-flow
  • Leak detection pump OFF malfunction
  • Leak detection pump ON malfunction
  • Vent valve ON (close) malfunction
  • Canister pump module (Reference orifice, leak detection pump, vent valve)
  • Connector/wire harness (Canister pump module - ECM)
  • EVAP system hose (pipe from air inlet port to canister pump module, canister filter, fuel tank vent hose)
  • ECM
While ignition switch OFF 2 trip
P043F Reference orifice high-flow
P2401 Leak detection pump stuck OFF
P2402 Leak detection pump stuck ON
P2419 Vent valve stuck closed

HINT:

The reference orifice is located inside the canister pump module.