On-Vehicle Inspection
WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK PARKING BRAKE SWITCH ASSEMBLY
- Remove the rear console box (see step 22 under REMOVAL
).
HINT:
Refer to the procedures from the removal of the No. 1 console upper panel garnish up until the removal of the rear console box sub-assembly. (See step 12 under REMOVAL ).
- Disconnect the parking brake switch connector.
- Measure the resistance of the switch.
Standard resistance
STANDARD RESISTANCE CHARTTester Connection Condition Specified Condition 1 - Body ground Parking brake switch ON (Switch pin released) Below 1 Ω 1 - Body ground Parking brake switch OFF (Switch pin pushed in) 10 kΩ or higher If the result is not as specified, replace the switch assembly.
- Remove the rear console box (see step 22 under REMOVAL
).