Inspection Procedure
WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (see CALIBRATION ).
- INSPECT CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (see DTC CHECK / CLEAR ).
Result
RESULT PROCEEDResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEM
A: GO TO NEXT STEP.
- Check if the CAN communication system DTC is output (see DTC CHECK / CLEAR ).
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER (VSC WARNING LIGHT)
- Select the ACTIVE TEST, generate a control command, and then check that the VSC warning light operates.
Skid control ECU
ITEM REFERENCEItem (Display) Test Details Diagnostic Note VSC WARN LAMP Turn VSC warning light ON / OFF Observe combination meter OK: The VSC warning light turns on or off.
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG: GO TO NEXT STEP.
- Select the ACTIVE TEST, generate a control command, and then check that the VSC warning light operates.
- CHECK COMBINATION METER ASSEMBLY
- Check the combination meter (see DIAGNOSIS SYSTEM ).
NG: REPLACE COMBINATION METER ASSEMBLY
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY