Inspection Procedure
WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (see CALIBRATION ).
- CHECK CAN COMMUNICATION SYSTEM
- Check if the CAN communication DTC is output (see DIAGNOSIS SYSTEM
).
Result
RESULT PROCEEDResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEM
A: GO TO NEXT STEP.
- Check if the CAN communication DTC is output (see DIAGNOSIS SYSTEM
).
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER (SKID CONTROL BUZZER)
- Select the ACTIVE TEST, generate a control command, and then check that the skid control buzzer operate.
Skid control ECU
ITEM REFERENCEItem (Display) Test Details Diagnostic Note BUZZER Turns skid control buzzer ON / OFF Buzzer can be heard OK: The skid control buzzer can be heard.
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG: GO TO NEXT STEP.
- Select the ACTIVE TEST, generate a control command, and then check that the skid control buzzer operate.
- INSPECT COMBINATION METER
- Inspect the combination meter (see PROBLEM SYMPTOMS TABLE ).
NG: REPLACE COMBINATION METER
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY