Inspection Procedure
WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (see DIAGNOSIS SYSTEM
).
Result
RESULT PROCEEDResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEM
A: GO TO NEXT STEP.
- Check if the CAN communication system DTC is output (see DIAGNOSIS SYSTEM
).
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER (ABS WARNING LIGHT)
- Select the ACTIVE TEST, generate a control command, and then check that the ABS warning light operates.
Skid control ECU
ITEM REFERENCEItem (Display) Test Details Diagnostic Note ABS WARN LAMP Turns ABS warning light / ON or OFF Observe combination meter OK: The ABS warning light turns on or off.
NG: CHECK METER / GAUGE SYSTEM
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
- Select the ACTIVE TEST, generate a control command, and then check that the ABS warning light operates.