LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Exterior) >> Rear Bumper >> Reassembly

Rear Bumper: Reassembly

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL REAR BUMPER EXTENSION MOUNTING BRACKET LH 
    1. Install the bracket to the back step reinforcement with the 2 nuts.

      Torque: 12.5 N*m (127 kgf*cm, 11 ft.*lbf) 

  2. INSTALL REAR BUMPER EXTENSION MOUNTING BRACKET RH 
    1. Install the bracket to the back step reinforcement with the 2 nuts.

      Torque: 12.5 N*m (127 kgf*cm, 11 ft.*lbf) 

  3. INSTALL NO. 1 SPARE WHEEL CARRIER LID 
  4. INSTALL REFLEX REFLECTOR ASSEMBLY LH 
    1. Install the reflector with the nut.

      Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf) 

  5. INSTALL REFLEX REFLECTOR ASSEMBLY RH 
    1. Install the reflector with the nut.

      Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf) 

  6. INSTALL REAR BUMPER REINFORCEMENT 
    1. Install the reinforcement with the 2 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Install the 2 clips.
scientia non olet · About LEMON Manuals