Back Door Support: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
A bolt without a torque specification is shown in the standard bolt table (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

INSTALL BACK DOOR SUPPORT
1. Install the back door support to the body with the bolt.
  Torque: 17.5 N*m (178 kgf*cm, 13 ft.*lbf)
2. Install the back door support to the back door with the bolts.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)