Back Door Support: Disposal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.

DISPOSE OF BACK DOOR SUPPORT

Remove the back door stay (see REMOVAL ).
Horizontally fix the support in a vise with the piston-rod pulled out.

Using a metal saw or equivalent, gradually cut any area between A and B to release the gas.

Fig 1: Cutting Any Area Between A & B To Release Gas

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard measurement

BACK DOOR

Area	Measurement
a	80 mm (3.15 in.)
b	20 mm (0.80 in.)

CAUTION: As metal debris may be blown outward by the gas, you must:

Wear protective glasses.
Cover the area being cut.

NOTE: The gas is colorless, odorless and harmless.