LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Theft Deterrent) >> Theft Deterrent System >> Data List/Active Test

Data List/Active Test

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON.
    3. Read the DATA LIST by following the displays on the tester.

      Theft warning ECU assembly: 

      DATA LIST - THEFT WARNING ECU ASSEMBLY

      Item Measurement Item/Display (Range) Normal Condition Diagnostic Note
      HOOD COURTESY SW Engine hood courtesy switch signal / ON or OFF ON: Engine hood is open
      OFF: Engine hood is closed      		 -
      GLS BRK DETECT Glass breakage sensor detect / ON or OFF ON: Glass breakage sensor operates
      OFF: Glass breakage sensor does not operate
      KEY UNLK WRN SW Unlock warning switch signal / ON or OFF ON: Key is inserted in ignition key cylinder
      OFF: No key is inserted in ignition key cylinder
      IG SW Ignition switch signal / ON or OFF ON: Key is ON or START position
      OFF: Key is OFF or ACC position
      PASSIVE MODE Passive mode / ON or OFF ON: Switched from active mode
      OFF: Switched to active mode
      WARN BY GLS SEN Warning by glass breakage sensor / ON or OFF ON: Warns when glass breakage is detected
      OFF: Does not warn when glass breakage is detected
      WARNING (HORN) Warning by horn / ON or OFF ON: Switched from armed state to alarm sounding state
      OFF: Switched from alarm sounding state to armed state or disarmed state
      ENTRY DELAY Entry delay time during passive mode / 0s, 14s or 30s 0s: Entry delay time is 0 sec.
      14s: Entry delay time is 14 sec.
      30s: Entry delay time is 30 sec.
  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON.
    3. Perform the ACTIVE TEST by following the displays on the tester.

    Theft warning ECU assembly: 

    ACTIVE TEST - THEFT WARNING ECU ASSEMBLY

    Item Test Detail Diagnostic Note
    SECURITY INDIC Security indicator light ON / OFF Connect terminals TC and CG of DLC3
    SECURITY HORN2 Security horn ON / OFF -
scientia non olet · About LEMON Manuals